- 99 -
Battery Charging
●
Remove the battery from the vehicle (refer to Battery Removal)
●
Connect the leads from the charger and charge the battery at a rate that is a tenth of the battery capacity. For
example, the charging rate for a 10Ah battery would be 1.0 ampere.
●
Ensure that the battery is fully charged before installation. (see Battery Installation)
CAUTION
Never remov
e the sealing strip, or the battery can be damaged. Don't install a conventional
battery in this motorcycle, or the electrical system can't work properly.
NOTE
If you charg
e the sealed battery, never fail to observe the instructions shown in the label on the
battery.
Battery
Removal
● Remove the seat. Remo
ve munting bolt of fuel tank.
● Disconnect the wires from the battery, first from the (-) terminal, then the (+) terminal.
●
Lift fuel tank rear part up, take the battery out of th
e box.
● Clean the battery with a solution of baking soda and water. Ensure that the wire connections are clean.
To Next Page
Loading...
