- 44 -
NOTE
The motorcyc
le is equipped with a roll-over sensor. Engine will stop automatically and
malfunction indicator light will flash when the motorcycle falls down. After righting the
motorcycle, turn the ignition key from “ ”to“ ” to erase errors.
Stopping the
Motorcycle in an Emergency
This switch is for driving safety and convenience, at the meantime, for meeting design and safety requirements.
It is essential that this switch can protect you, owner and operator from danger. Two of the most common causes
of throttle failure are:
1. Improper service or wrong valve clearance may cause dirt and dust entering into air inlet system.
2. During removal of the air cleaner, dirt may enter into and block fuel injection system.
In an emergency situation such as throttle failure, vehicle can be stopped by applying the brakes and holding the
clutch lever. Once thoes stopping procedures are performed first, the engine stop switch can be used to stop the
engine. After the engine stop switch is used, turn off the ignition switch at “ ” position .
To Next Page
Loading...
