24
14
Electrical Connections (continued)
- If a remote time clock is to be fitted, using a volt-free switching time clock, connect the switching wires from the time
clock following points above (see also
Diagram B Fig. 31).
- If using an external time clock and room thermostat, these must be connected in series as above (see also
Diagram
C Fig. 31
).
Live and Neutral connections to operate the clock motor must be taken from a suitable source.
Connector
J12 (Fig. 30), is provided for connecting an optional integral time clock or programmer, for fitting instructions,
please refer to those provided with the clock.
Fig. 31
Connector D
Connector D
Connector D
To Next Page
Loading...
