Chaffoteaux & Maury MINIMA MX2 24 FF NG - Removing the Electrodes

33
22.2.4 Removing the burner
1. Carry out steps 22.2.1, 22.2.1 and 22.2.2;
2. Remove the two self tapping screws “F” securing the
burner (see Fig. 48);
3. Pull the burner out of the combustion chamber (see
Fig. 53)
;
4. Remove the self tapping screws securing the
electrodes
(see Fig. 54)
5. Reassemble in reverse order;
6. Carry out combustion tests using the test point on
the turret
1. Carry out steps 22.1.1 and 22.2.1;
2. Unscrew the self tapping screws (see Fig. 49);
3. Disconnect the lead from the wiring loom (see Fig. 50);
4. Remove the electrodes (see Fig. 51);
5. Reassemble in reverse order.
22.2.3 Removing the electrodes
Fig. 49
Fig. 50
Fig. 51
Fig. 52
Fig. 53
Fig. 54
F