Chaffoteaux & Maury MINIMA MX2 24 FF NG - Control System Component Servicing

40
22.5 Access to the Control System
1. Isolate electricity;
2. Carry out step 22.1.1;
3. Pivot the electrical box downward as step 22.1.3;
4. Remove the two screws “V1” (see Fig. 95);
5. Pivot the electrical box to its original position;
6. Remove the two screws “V2” and pull toward you
unlocking the two clamps “V3” (see Fig. 96 & 97);
7. Remove the two screws “V4” (see Fig. 98) on the
PCB, unplug the electrical connections
8. To remove it pull the PCB towards you;
9. Reassemble in reverse order.
22.5.1 Removing the P.C.B.s
Fig. 95
V1
Fig. 96
Fig. 97
22.5.2 Removing the fuses
1. Carry out steps 22.5.1 ;
2. Remove the fuses “X” (see Fig. 99)
3. Reassemble in reverse order.
Fig. 99
Fig. 98
V3
V2
V4
X