Challenge EH-3C - Table of Contents

iii
F.352-KO/EH-3C DRILL/AUG 03
TABLE OF CONTENTS
INTRODUCTION ........................................................................................... ii
SAFETY PRECAUTIONS ..............................................................................v
CAUTION: POWER LOCK-OUT PROCEDURE .............................................v
WARNING LABEL DEFINITIONS ..................................................................vi
SPECIFICATIONS ....................................................................................... vii
PACKING LIST .......................................................................................... viii
1.0 INSTALLATION .................................................................................... 1-1
1.1 UNCRATING THE PAPER DRILL ................................................... 1-2
1.2 INSTALLING THE TABLE AND BACKGAUGE ................................ 1-2
1.3 INSTALLING THE DRILL BLOCKS AND DRILLS ............................ 1-3
1.4 HYDRAULIC LEVEL CHECK......................................................... 1-3
1.5 HOOKING UP THE POWER LINE ................................................. 1-3
1.6 INSTALLING THE CHIP CONTAINER ............................................. 1-3
2.0 OPERATION ....................................................................................... 2-1
2.1 STARTING THE MACHINE ............................................................ 2-1
2.2 OPERATING THE DRILL ............................................................... 2-1
2.3 ADJUSTING THE VERTICAL STROKE .......................................... 2-1
2.4 SETTING THE DISTANCE BETWEEN DRILL HEADS .................... 2-1
2.5 SETTING THE BACKGAUGE POSITION ....................................... 2-1
2.6 USING THE SIDE GUIDE .............................................................. 2-2
2.7 ADJUSTING THE STROKE SPEED ............................................... 2-2
2.8 REMOVING THE CUTTING BLOCKS ............................................ 2-2
2.9 REMOVING DRILLS FROM THE SPINDLE.................................... 2-2
2.10 DRILLING TIPS ........................................................................... 2-3
3.0 ACCESSORIES .................................................................................. 3-1
3.1 GENUINE CHALLENGE HOLLOW DRILLS.................................... 3-1
3.2 CHALLENGE DRILL-EASE LUBRICANT STICK ............................. 3-1
3.3 CHALLENGE DRILLING BLOCKS ................................................. 3-1
3.4 HANDI-SHARP DRILL SHARPENER ............................................. 3-2
3.5 HOLLOW DRILL SHARPENER / CHIP REMOVER ........................ 3-2
3.5.1 Using the Chip Remover ....................................................... 3-2
3.5.2 Using the Drill Sharpener ..................................................... 3-2
3.6 RIGHT-SIDE SIDEGUIDE KIT ........................................................ 3-3
3.7 AUTO-TRIP BACKGAUGE ............................................................ 3-3
3.7.1 Setting the side guide stops ................................................. 3-3
3.8 FIXED GAGES ............................................................................. 3-4
3.9 TWO-HAND CONTROL KIT ........................................................... 3-5
3.10 DRILL SHIELD KIT ...................................................................... 3-6