Challenger Lifts 24012 W User Manual

Challenger Lifts, Inc.
Model’s 24012*
*( E, W, EW, XL, LR, AR)
FOUR POST SURFACE
MOUNTED LIFT OPERATION, INSTALLATION &
MAINTENANCE MANUAL
IMPORTANT!!!
READ THIS MANUAL COMPLETELY BEFORE INSTALLING OR OPERATING THE LIFT
200 Cabel Street, P.O. Box3944
Louisville, Kentucky 40201-3944
Email - sales@challengerlifts.com
Web Site -www.challengerlifts.com
Office (502) 625-0700 Fax (502) 587-1933

Challenger Lifts 24012 W Specifications

General

Model	24012 W
Category	Lifting Systems
Lifting Capacity	12, 000 lbs
Hydraulic System Working Pressure	3000 psi
Voltage	220V
Phase	1
Frequency	60 Hz
Lift Type	Two Post Lift
Power Supply	Electric/Hydraulic
Overall Height	145 inches

Summary

Installation Procedure

Location and Site Requirements

Determining lift location, overhead clearance, and floor specifications.

Layout and Marking

Initial Post and Beam Assembly

Anchor Bolt Installation

Hole Preparation and Cleaning

Drilling perpendicular holes and cleaning them for anchor bolt installation.

Anchor Bolt Assembly and Seating

Assembling washer/nut and seating anchor bolts into the prepared holes.

Bolt Tightening Specifications

Lift Operation Instructions

Lockout/Tagout Procedures

Raising Vehicles

Vehicle Placement and Brake Setting

Raising the Lift

Engaging Safety Latch

Lowering lift onto safety latch and verifying latch pin engagement.

Maintenance

Daily Maintenance Checks

Inspecting for loose anchor bolts, fluid leaks, and loose connections.

Trouble Shooting Guide

Lift Will Not Rise

Troubleshooting common issues when the lift fails to rise.

Lift Will Not Lower

Troubleshooting common issues when the lift fails to lower.

Lift Drifts Down

Troubleshooting lift drift when upward travel stops.

Lift Not Lifting to Top Position

Troubleshooting lift issues when it cannot reach the top position.