7 . ACCESSORIES AND OPTIONS
7.49
Challenger MT500B EU
7
7.10.2.5 - Selecting the language
• Press the key
«
5
when the window (Fig. 85) is open.
The window (Fig. 87) is displayed.
• Select the language by rotating the encoder.
• Validate by pressing the encoder. The main menu is dis-
played.
To exit the SETTINGS application, press ESC key.
7.10.2.6 - Setting the servicing schedule
This menu allows a warning message to be displayed to re-
mind the driver that the tractor must be serviced.
IMPORTANT: The first servicing must take place after
50 hours and the second after 400 hours. Servicing
should then take place every 400 hours. See Chapter 5,
section 5.2 (Service guide).
For the first two servicings:
The DATATRONIC is factory set. Therefore, a warning
message will appear after 30 hours for the first servicing
and after 350 hours for the second servicing.
Operation :
When the number of hours exceeds 30 hours, a warning
message will be displayed regardless of which window is
active. Example: (Fig. 88).
Description (Fig. 88)
9. Number of actual tractor hours (identical to the
number of hours displayed on the instrument panel
digital display)
10. Total number of hours before the next servicing
11. Number of hours remaining before next servicing (30 -
50 = -20)
NOTE: This message is also displayed at each start-up
(Fig. 89).
• To cancel the message, press the key ESC.
When the servicing has been carried out, it should be vali-
dated. For this purpose:
• Press the key
«
6
when the window (Fig. 85) is open.
The window (Fig. 90) is displayed.
L Ga Km Mi
Z3A-815-08-04-B
Fig. 87
ENGLISH
DEUTSCH
ESPAÑOL
ITALIANO
NORSK
SVENSKA
ESTONIAN
PORTUGUES
POLISH
NEDERLANDS
FRANÇAIS
ENTRETIEN
PROCHAIN ENTRETIEN = 50
OK
+ -
PRESS ESC ! ! !
: 30 H
: 50 H
< -20 h >
Z3A-1375-12-04
Fig. 88
9
10
11
1
2
3
4
5
6
ESC
PRESS ESC ! ! !
: 180 H
: 200 H
< -20 h >
Z3A-1372-12-04
Fig. 89
To Next Page
Loading...
Need help?
General
