PROGRAMMING
Start with your garage door, gate, or commercial door
closed.
Press and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
1
2
IMPORTANT: The remote will activate your door or gate during
programming. Ensure door or gate is clear of ALL obstructions.
NOTE: If the Mini Universal Remote Control is being
programmed to a Genie Garage Door Opener, visit
LiftMaster.com for programming instructions.
LED
Bottom
Button
The Mini Universal Remote Control comes preset to work with
LiftMaster Security+ 2.0
®
operators. It is not necessary to place
the remote into program mode for theses products. Use the
following programming instructions.
To Next Page
Loading...
