Chamberlain 374UT User Guide

warning
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
Activate the gate or door ONLY when it can be seen clearly is properly adjusted and there are no obstructions to door travel.
ALWAYS keep the gate or garage door in sight until completely closed. NEVER permit anyone to cross the path of the moving gate or door.
Read instructions thoroughly BEFORE beginning.
If using the Mini Universal Remote Control with residential door openers, the remote control must be used only with door openers manufactured after 1993 that utilize
photoelectric sensors. The photoelectric sensors are always located on or near the bottom of the door track.
The Mini Universal Remote Control is compatible with the following brands which use a program/learn button:
Garage Door Opener
Brand
Type/Color of
Program/Learn button
Year
Linear® Mega-Code ’97-Current
LiftMaster®* Orange/Red ’97-’03
LiftMaster®* Purple ’05-Current
LiftMaster
®
*
Green ’93-’96
Genie® Overhead Door® Intellicode ’95-Current
Genie Overhead Door
®
**
Intellicode ’05-Current
Stanley
®
Secure Code ’98
LiftMaster®* Yellow ’11-Current
Wayne Dalton® Rolling Code ’99
* Chamberlain®, Do-It ®, Master Mechanic ®, Raynor ®, True Value ®, and Sears Craftsman® are compatible with LiftMaster ® technology.
** For Genie Intellicode II programming, go to www.LiftMaster.com/374ut to download the full manual.
Contents [ hide
1 PROGRAMMING
2 TEST
3 File Downloads
4 References
5 Related Manuals
PROGRAMMING
IMPORTANT: The remote will activate your door or gate during programming. Ensure the door or gate is clear of ALL obstructions.
NOTE: If the Mini Universal Remote Control is being programmed to a Genie Garage Door Opener, visit LiftMaster.com for programming instructions.
The Mini Universal Remote Control comes preset to work with LiftMaster Security+ 2.0® operators. For LiftMaster Security+ 2.0® operators, press and release the
operator’s LEARN button. Then press and hold the remote button to complete programming. For all other garage door openers, gate operators, and commercial door
operators, follow the programming steps below.
1. Start with your garage door, gate, or commercial door closed.
2. Press and hold the bottom button on the remote control until the blue LED stays solid (approximately 15 seconds) then release the button. LED Bottom Button

Chamberlain 374UT Specifications

General

Brand	Chamberlain
Model	374UT
Category	Remote Control
Language	English