Name: Chamberlain 374UT
Brand: Chamberlain
Rating: 4 (1 reviews)

To Next Page

To Previous Page

5. When the garage door opener or gate opener moves, immediately press and release either of the buttons on the remote control to confirm the code and exit

programming.

TEST

Test the remote control by pressing the button you programmed in step 4. If the garage door opener does not activate, repeat the programming steps or visit

LiftMaster.com/374ut for additional instructions.

NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modiﬁcations of this receiver and/or transmitter are prohibited, except for changing the

code setting or replacing the battery. THERE ARE NO OTHER USER-SERVICEABLE PARTS.

Tested to comply with FCC Standards FOR HOME OR OFFICE USE. This device complies with Part 15 of the FCC Rules and Industry Canada (ISED/ IC) RSS-210.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

REMOTE CONTROL BATTERY

warning

To prevent possible SERIOUS INJURY or DEATH:

NEVER allow small children near batteries.

If the battery is swallowed, immediately notify the doctor. To reduce the risk of fire, explosion, or chemical burn:

Replace ONLY with 3V CR2032 coin batteries.

DO NOT recharge, disassemble, heat above 212°F (100°C), or incinerate.

Dispose of batteries properly. Replace ONLY with 3V CR2032 coin batteries.

LiftMaster.com

1-800-442-1255

All trade names used herein are trademarks of respective manufacturers listed.