Chamberlain 8155 - Programming - Multi-Function Control Panel

7
LEARN
Button
LOCK
Button
Operation
Features
Lock NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will
still allow access to your garage.
Activate: Press and hold the LOCK button for 2 seconds. The command LED will fl ash as long as the
lock feature is activated and your handheld remote control will not operate your door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop
fl ashing and normal operation will resume.
Light To change the amount of time the garage door opener lights will stay on (default time is 4-1/2
Minutes):
Press and hold the LOCK button until the garage door opener lights fl ash.* The garage door opener
lights will then indicate the current light duration by fl ashing up to 4 times (see table below).
To change the light duration time repeat the steps above until the lights fl ashes indicate your desired
time frame.
NOTE: Factory setting is on.
This feature will turn on the garage door opener lights when the safety reversing sensors beam has
been broken.
Deactivate: Start with the garage door opener lights off. Press and hold the LIGHT button to turn on
the light, continue to hold until the light turns off.*
Activate: Start with the garage door opener lights on. Press and hold the LIGHT button to turn off
the light, continue to hold until the light turns on.*
* Approximately 10 seconds
To Program
a Remote
Control or
Keyless Entry
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will fl ash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identifi cation number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
The garage door opener lights will fl ash (or two clicks will be heard) when the code has been
programmed. If programming is unsuccessful, repeat steps 1-3 or program the remote using the
learn button on the garage door opener.
Maintenance
Alert System
(MAS)
Activate/Deactivate
NOTE: Factory setting is on.
Press and hold the LEARN button. Then press the LIGHT button. The service LED will fl ash the
status; Activated is 2 fl ashes and deactivated is 3 fl ashes.
NUMBER OF TIMES GARAGE DOOR OPENER LIGHTS FLASH 1234
TIME THE GARAGE DOOR OPENER LIGHT STAYS ON 1½ Minutes 2½ Minutes 3½ Minutes 4½ Minutes
Service
LED
LIGHT
Button
Command LED
Programming - Multi-Function Control Panel