Wireless Keypad 8747AML
Using the (purple) learn button:
1.Press and release the (purple) learn button (1) on the
opener (the orange LED will light).
2.Within 30 seconds, enter a four digit personal
identification number (PIN) of your choice on the
keypad (2), then press and hold the ENTER button.
3.Release the button when the opener courtesy LEDs
flash once (3) (the code is learned).
Alternate programming method using the multi-
function control panel (optional accessory):
NOTE: This method requires two people if the
keyless entry is already mounted outside the
garage.
1.Enter a four digit personal identification number (PIN)
of your choice on the keypad (then press and hold
ENTER).
2.While holding the ENTER button, press and hold the
LIGHT button on the multi-function control panel.
3.Continue holding the ENTER and LIGHT buttons while
you press the push bar on the multi-function control
panel (all three buttons are held).
4.Release buttons when the opener courtesy LEDs
flash once.
Activate the opener only when the door is
in full view, free of obstruction and
properly adjusted. No one should enter or
leave garage whilst the door is in motion. Do not
allow children to operate push button(s) or
transmitter(s). Do not allow children to play near
the door.
19
11
KEYLESS DEVICE PROGRAMMING
(OPTIONAL ACCESSORIES )
To Next Page
Loading...
Need help?
General
