To Next PageTo Next Page
Need help?Do you have a question about the Chamberlain LA 400PKGU and is the answer not in the manual?
General| Type | Swing Gate Opener |
|---|---|
| Max Gate Weight | 400 lbs |
| Max Gate Length | 16 ft |
| Operating Temperature | 14°F to 122°F |
| Control Board | Yes |
| Safety Features | Safety Sensors, Obstruction Detection |
| Power Consumption (Standby) | 5W |
| Gate Weight Capacity | 400 lbs |
| Gate Width Capacity | 16 ft |
| Motor Type | DC Motor |
| Remote Control | Included |
| Battery Backup | Optional |
| Power Source | AC |
| Connectivity | Wi-Fi |
| Voltage | 120V |
Requirements for entrapment protection devices on automated gates.
Crucial safety precautions for installation and operation.
Guidelines for safe installation practices for gate operators.
Standards for gate design and construction for safety.
List of items included in the gate operator package.
List of hardware components provided with the gate operator.
Additional items available for purchase to enhance gate operator functionality.
Technical data and performance characteristics of the gate operator.
Procedures for preparing the installation site according to codes.
Essential checks for the gate structure before operator installation.
Visual guide to a standard gate operator installation setup.
Practical advice and best practices for installing the gate operator.
Step-by-step instructions for attaching mounting brackets to the operator arm.
Methods for accurately determining the correct mounting position for brackets.
Procedure for positioning the gate operator arm and brackets on the gate post.
Steps for firmly attaching the operator brackets to the gate post and gate.
Guidelines for mounting the control box on a wall, column, or post.
Instructions for installing an earth ground rod for electrical safety.
Connecting the operator arm's cable to the main control board.
Steps for configuring wireless communication between dual gate operators.
Procedures for wiring two gate operators together for dual gate operation.
Configures bipart delay for single/dual control boxes in dual gate systems.
Installing required safety devices like sensors to prevent entrapment.
Information about the control board's role and connection points.
Details regarding the use and connection of an optional expansion board.
Instructions for connecting the gate operator to the AC power source.
Final steps to complete the gate operator installation process.
Adjusting the gate's open/close limits and operating force.
Initial procedure for setting gate travel limits and force.
Fine-tuning gate travel limits after initial setup or reset.
Adjusting the operator's force setting for optimal performance and safety.
Testing the gate operator's obstruction sensing and reversal function.
How to program remote controls to operate the gate.
Steps to connect and program the LiftMaster Internet Gateway.
Procedure to clear all stored remote control codes from the operator.
How to reset the gate's programmed travel limits.
Steps to remove and clear monitored entrapment protection devices.
Explanation of the main control board components and their functions.
How to disengage the operator from the gate for manual operation.
Functions and usage of the operator's reset button.
How to enable or disable Party Mode for continuous gate operation.
Understanding the operator alarm and its causes.
How programmed remote controls function to operate the gate.
Wiring instructions for external devices like exit probes and loops.
Wiring diagrams for connecting magnetic (Maglock) and solenoid locks.
Wiring for single button controls and accessory power.
Critical safety warnings applicable to all maintenance procedures.
A schedule for performing routine maintenance tasks.
Understanding and interpreting diagnostic codes displayed by the operator.
Explanation of the status and input LEDs on the control board.
A guide to diagnosing and resolving common gate operator issues.
Illustrations and descriptions of different gate bracket types.
Information on installing and configuring solar panels for gate operation.
How to set gate limits using a remote control.
Part numbers and descriptions for control box components.
Part numbers and descriptions for the gate operator arm assembly.
Schematic showing electrical connections for the standard control box.
Various monitored entrapment protection devices compatible with the operator.
Different types of LiftMaster remote controls for gate operation.
Other accessories like keypads, loop detectors, and battery components.
Details of the product's limited warranty terms and conditions.
