Chamberlain PowerDrive PD210 User Manual

The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.chamberlain.com
CONTENTS
Preparation .............................. 1-4
Assembly ................................. 5-9
Installation ............................ 10-19
Install the Door Control ............. 20-21
Install the Protector System
®
...... 22-25
Power .................................. 26-27
Adjustments .......................... 28-30
Operation.................................. 31
Using Your Garage Door Opener ...... 32
Using the Wall-Mounted
Door Control .............................. 32
To Open the Door Manual .............. 33
Care of Your Opener ..................... 33
Having a Problem? ...................... 34
Diagnostic Chart ......................... 35
Programming ......................... 36-37
The Remote Control Battery ............ 38
Accessories ............................... 39
Warranty .............................. 40-41
Repair Parts .......................... 42-43
1/2 hp Chain Drive
Garage Door Opener
■ Please read this manual and the enclosed safety materials carefully!
■ Fasten the manual near the garage door after installation.
■ The door WILL NOT CLOSE unless the Protector System
®
is connected and
properly aligned.
■ Periodic checks of the garage door opener are required to ensure safe
operation.
■ The model number label is located on the front panel of your garage
door opener.
FOR RESIDENTIAL USE ONLY
Serial Number:
Date of Purchase:
Write down the following information
for future reference:
.
.
PD210 • PD212D •
LW2000 • HD200D •
248730
PD610D • PD612D •
HD400D • LW3000
There are two type of garage door openers pictured.
Yours may appear slightly different.
®

Chamberlain PowerDrive PD210 Specifications

General

Horsepower	1/2 HP
Drive System	Chain Drive
Remote Control	Yes
Security+ Rolling Code Technology	Yes
Battery Backup	No
Max Door Height	7 ft
Safety Features	photoelectric sensors

Summary

Installation

IMPORTANT INSTALLATION INSTRUCTIONS

Critical safety warnings and essential instructions before starting garage door opener installation.

STEP 1 Determine the header bracket location

Guidance on finding the correct position for the header bracket based on door type and clearance.

STEP 2 Install the header bracket

Instructions for mounting the header bracket securely to the wall or ceiling.

STEP 3 Attach the rail to the header bracket

STEP 4 Position the garage door opener

STEP 5 Hang the garage door opener

Procedures for securely hanging the motor unit using hanging brackets and structural supports.

STEP 7 Attach the emergency release rope and handle

STEP 8 Install the door bracket

Instructions for mounting the door bracket to the garage door, with variations for door types.

STEP 8 Install the door bracket (continued)

Specific steps for installing the door bracket on one-piece garage doors.

STEP 9 Connect the door arm to the trolley

STEP 9 Connect the door arm to the trolley (continued)

STEP 10 Install the door control

STEP 11 Wire the door control to the garage door opener

STEP 13 Install the Protector System®

Instructions for mounting and aligning the safety reversing sensors.

STEP 13 Install the Protector System® (continued)

Details on wall and floor mounting options for the safety reversing sensors.

STEP 14 Wire the Safety Reversing Sensors

STEP 14 Wire the Safety Reversing Sensors (continued)

STEP 15 Connect power

Steps for connecting the garage door opener to a power source, including wiring options.

STEP 16 Ensure the safety reversing sensors are aligned

Procedures for verifying the alignment and functionality of the safety reversing sensors.

Adjustments

Step 1 Adjust the UP and DOWN Travel Limits

Guidance on setting the open and close travel limits for the garage door opener.

Step 2 Adjust the Force

Instructions for adjusting the force settings for opening and closing the garage door.

STEP 3 Test the Safety Reversal System

Procedures for testing the safety reversal system using an obstruction.

STEP 4 Test the Protector System®

Steps to test the functionality of the safety reversing sensors with an obstruction.

Operation

IMPORTANT SAFETY INSTRUCTIONS

Comprehensive safety warnings for operating the garage door opener.

Using Your Garage Door Opener

Having a Problem?

Diagnostic Chart

PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON

PROGRAM A REMOTE CONTROL USING THE MULTI-FUNCTION DOOR CONTROL

To Add, Reprogram or Change a Keyless Entry PIN