To Next PageTo Next PageWhat to do if there is low or no water in my Champion PRO Dishwasher?
If your Champion Dishwasher is not getting enough water, check these items: * Ensure the main water supply is on by opening the supply valve. * Verify the PRV setting is at 20 PSI. * Clean the solenoid strainer if clogged. * If the solenoid valve is defective, contact a service agent.
What to do if the door symbol appears on my Champion Dishwasher?
If the door symbol appears on the display of your Champion Dishwasher, it means the door is open. Make sure to close all doors completely.
Why my Champion PRO Dishwasher will not run?
If your Champion Dishwasher will not run, there are several possible causes: * The door might not be completely closed, so ensure it is. * The main power could be off; check the breaker on the panel. * The dishwasher itself might be off; turn it on. * The dish rack might not be properly inserted; insert the dish rack.
How to improve poor wash results in my Champion PRO Dishwasher?
If you're experiencing poor wash results with your Champion Dishwasher, consider the following: 1. Check the detergent supply and replenish if low. 2. Avoid overloading the wares; reposition or reduce the amount. 3. Clean any clogged screens. 4. Clean clogged spray arms. 5. Check the spray arms for missing end plugs. 6. Verify the incoming water temperature is adequate.
Why does the conveyor keep stopping on my Champion Dishwasher?
If the Champion Dishwasher conveyor stops, it might be because the dwell feature was enabled. Avoid touching the ‘DWELL’ button when loading a rack. Also, check the conveyor for any jams. Another cause may be that the table limit switch has stopped the conveyor; in this case, remove racks from the unload end of the machine.
General| Brand | Champion |
|---|---|
| Model | PRO Series |
| Category | Dishwasher |
| Language | English |
