MagicQ Training Course
14 of 21 – Part Three: Maintenance
www.chamsys.co.uk
In order to replace a component in MagicQ products, you will need the tools for that
product and a good quality soldering iron.
Component replacements can be obtained from ChamSys or your local distributor.
! MAINTENANCE SHOULD BE CARRIED OUT BY
EXPERIENCED AND QUALIFIED PERSONNEL !
Replacing Key Caps
Key caps can be levered off using two flat head
screwdrivers. Place one each side and apply
even pressure to the key to prevent the switch
from breaking. The new key cap can simply be
pressed on. Key caps can be purchased
individually or as an entire kit for a product.
Replacing Faders
To replace the faders on the MagicQ Compact console, remove front panel from the
console as detailed above.
Completely desolder the six solder joints for that fader. The holes must be completely
free of solder to allow the fader to be removed. Place the new fader into the holes and
solder the connections. We recommend the use of high quality lead free solder.
ChamSys part no for replacement faders for the MQ40/40N/60/70 is: 308-002
To Next Page
Loading...
