CHANCEE M50 - Checking Brush Plate Wear; Checking Squeegee Strip Wear; Adjusting the Squeegee Height

3.1.4 Checking the degree of wear of the brush plate
 Check whether the brush plate is worn. If so, adjust the height of the brush plate or
replace it.
3.1.5 Checking the degree of wear of the strip
The strip needs to be replaced if:
 the strip cannot touch the ground when the squeegee is put down, or

the strip is cracked.
3.2 Adjustment of the squeegee

Use the nuts on the universal wheels to lift or lower the squeegee. Make sure that the squeegee touches the ground during
your work.
7