4.4 Stopping the machine
When the work is finished, discharge the sewage tank.
Move the machine to an appropriate storage place.
Turn off all the buttons on the controlling panel.
Lift the brush plate and the squeegee.
Note: if the machine is not about to be used for a long time, please fully charge the batteries, disconnect the battery cords
to avoid power loss.
4.5 Charging the batteries
Note: the machine is powered by two 12 V maintenance-free lead-acid batteries and the total system voltage is 24 V.
The total voltage of the batteries will gradually decrease during the work. When the last bar of the voltmeter is flashing, the
machine is running out of power and charge the batteries immediately.
When maintaining the batteries, please wear gloves to avoid contact with acid substances.
Check whether the battery cords are worn and the connecting parts are loose, and replace them when necessary.
Keep the batteries dry and clean and make sure that there are no dust on them, since it is extremely harmful to the batteries
and may even cause them to burn in severe cases. Do NOT put any object (especially metallic object) on the batteries either.
In order to extend the service life of the batteries, charge them immediately when the cleaning work is finished. Deep
discharging is strictly forbidden for it will reduce their capacity and service life.
The correct steps of charging the batteries: first install the batteries, then connect them to the mains.
If the machine is not about to be used within a long period of time, please fully charge the batteries and disconnect the battery
cords.
To Next Page
Loading...