Chapter 5 Cleaning and maintenance of the machine
Regular maintenance can extend the service life of your machine.
5.1 Cleaning of the machine
Check the wheels regularly and remove entanglements.
Clean the sewage tank and the sewage discharging pipe with clean water regularly.
Clean the filter of the water valve. If there are impurities in its transparent cover, unscrew the filter and wash the cover
and the filter screen repeatedly.
Alert: do NOT wash the machine body with water directly, since it is NOT strictly water-proof and may be short-circuited or
burnt in this case.
5.2 Maintenance of the machine
5.2.1 Replacement of the brush plate
Part the machine on the flat ground and put down the brush plate.
Rotate the plastic handle counterclockwise to remove the brush.
Grab the bristles, lift the brush plate slightly and shake it from side to side, and then the brush plate will be removed.
When installing the new brush plate, make sure that the flange plate is aligned with the holes on the brush plate, and rotate it
in any direction to finish the installation.
Installation of the needle plate: add a scouring pad on the bottom of the needle plate, and install it following the instructions
above. You can purchase needle plates and scouring pads from the original manufacturer.
To Next Page
Loading...