Changan CS35 2012 - Maintenance Schedule; Description and Operation; Maintenance Items

CS35 2013.04
1.1.4-1 1.1.4-1Maintenance Schedule
Description and Operation
Maintenance Items
Pay special attention to safety to prevent acci-
den
t
s
before vehicle inspe
c
tio
n
. Pay special
attention to the following situation:
1. Do not start the engine in the forbidden area.
2. If it is necessary to start engine in
maintenance, apply the parking brake
comp
letely an
d set th
e gearshif
t lever at
n
eutral.
3.
Do
not tou
c
h a
n
y componen
t of ignition
system
af
te
r st
arting the
engine.
4.
Kee
p
the
hands, clothe
s, to
ols and o
t
her
th
ings
away
fro
m
cooling fan and drive
b
e
lt
a
nd any other ro
t
a
t
i
ng comp
onent
s whe
n
the
e
ngine
opera
t
es.
5. Do not touch any heat extraction
comp
onent
s, such as: exhaust man
i
fold
, air
condition high pressure pipe and muffler in
order to avoid being scalded.
6.
Kee
p
e
l
ectrical con
duct
o
rs away
fro
m the
battery cathode and anode to avoid short-
circuit and accidents such as battery damage,
fire and
exp
l
osion.
7. Do not drain the fluid of the vehicle, such as
gasoline, oil, coolant, brake fluid and etc. The
fluid
may pollute e
n
vironment.
8.
Prevent water
fro
m
ente
r
ing th
e cont
rol unit in
clea
ning and
mainte
nance.
9. The electronic control system adopts high
pressure oil supply. The oil circuit maintain
h
i
gh
pressur
e
g
a
soline
even
if
the
e
ngine
is
not running. Replace all oil tubes and fuel
filters in
a well-vent
ilat
ed place.
10. Since the throttle limiting screws of the
e
l
ectronic cont
rol syste
m
have been
a
d
justed
during production. Do not try to adjust the
th
rottle
limiting screws at
any t
ime
. If it is
e
l
ectronic th
rottle,
rep
l
ace it entirely
. Do
not
allow to disassemble and repair it.
11.
Do
not
raise the temperatu
r
e of electronic
control unit to over 80 ℃ in the malfunction
heating simulation or the maintenance that
may increase
the te
mperature of
vehicle.
12. Disconnect the wiring harness connectors of
a
ll contro
l mo
dule
s
and
the powe
r wire of
battery in welding.
13. Do not install the equipment which may
produce electromagnetic interference near
t
he electro
n
ic con
t
rol u
n
it
to prevent
interfe
r
ence.
14
.
Place
the ign
i
tio
n
switch to position
"LOCK"
whe
n
discon
necting the
contro
l mo
dule
wiring
harness connector.
1
.
1
.
4
M
a
i
n
t
enance
Schedule