Holdcoupling nutand regulator
asshown for properconnection
to LP cylinder valve.
6.Turn the coupling nut clockwiseand tighten to a full stop. The
regulatorwill seal on the back-check feature in the LP cylinder
valve, resulting in some resistance. An additional one-half to
three-quarters turn isrequired to complete the
connection. Tighten by hand only - do not use tools.
NOTE:
If you cannot complete the connection, disconnect regulatorand
repeat steps 5 and 6. If you are still unable to completethe
connection, do not use this regulator!
Leak Testing Valves, Hose and Regulator
1.Turn all grill control knobs to OFF.
2.Be sure regulator istightly connected to LP cylinder.
3.Completelyopen LP cylinder valve by turning hand wheel
counterclockwise. If you hear a rushing sound, turn gas off
immediately.There is a major leak at the connection. Correct
before proceeding.
4.Brush soapy solution onto areas circled below, or other similar
fittings on your grill.
Do not insert any tool or foreignobject into the valve
outlet or safety relief valve. You may damage the valve
and cause a leak. Leaking propane may result in
explosion,fire, severe _ersonal injury,or death.
Outdoor gas appliance is not intendedto be installed
in or on a boat.
Outdoor gas appliance is not intendedto be installed
in or on an RV.
• Never attemptto attach this grill to the self-contained
LP gas system of a campertrailer or motorhome.
• Do not use grill until leak-tested.
• If a leak is detectedat any time, STOP and call the fire
department.
• If you cannot stop a gas leak, immediately close
LP cylinder valve and call LP gas supplier or your fire
department!
5.If "growing" bubbles appear, there is a leak. Close LP
cylinder valve immediately and retighten connections. If leaks
cannot be stopped do not try to repair. Call for replacement
parts.
6.Always close LPcylinder valve after performing leak test by
turning hand wheel clockwise.
To Next Page
Loading...
