To Next PageTo Next PageWhy does Char-Broil Grill timer not work?
If the timer on your Char-Broil grill does not work and the green light does not flash, it could be due to a dead battery, so replace the batteries. Also, check if the batteries are installed incorrectly and install them correctly. Finally, make sure that the knob position started the Clean Cycle by pushing the knob in to start the clean cycle. The green LED should begin to flash.
General| Model Number | 463250211 |
|---|---|
| Type | Gas Grill |
| Fuel Type | Propane |
| Burners | 3 |
| Side Burner BTUs | 10, 000 |
| Burner Material | Stainless Steel |
| Side Shelves | Yes |
| Wheels | Yes |
| Ignition System | Electronic |
Guidelines for safe storage, handling, and use of LP cylinders with the grill.
Detailed instructions for securely connecting the regulator to the LP cylinder valve.
Instructions for performing a leak test on the grill's gas system components like valves, hose, and regulator.
Warnings about inserting tools into valve outlets and potential hazards of leaking propane.
Key safety guidelines for operating the grill, including clearance, ventilation, and material management.
Critical safety steps for lighting the grill and handling the LP cylinder during operation.
Step-by-step guide for safely igniting the main burners using the electronic ignitor.
Warnings about ignition failures and the correct use of controls during lighting.
Details the scope of coverage, periods, and types of failure covered by the limited warranty.
A detailed list of all grill parts with their corresponding keys and quantities.
Guidance for two people to lift and place the grill head onto the cart, aligning slots and ensuring regulator hose placement.
Procedures for filling, leak testing, and securely installing the LP tank into the grill cart.
Possible causes and solutions for gas leaks from hoses, cylinders, valves, and connections.
Causes and solutions for fires involving the control panel or grease buildup.
Troubleshooting steps for burners not lighting with the electronic ignitor or a match.
Diagnosing issues where no sparks or noise are heard from the spark module.
