4
When using electrical components under increased safety requirements,
always comply with the appropriate regulations.
Improper installation will render the warranty null and void.
Ensure the voltage marked on the power supply unit matches your main
power supply.
This device is designed for use indoors.
Observe the permissible ambient temperatures for use
Ensure that the patient does not lean against the device risk of falling
The device meets the requirements for electromagnetic compatibility. Do not
exceed the maximum values specified in the applicable standards.
If you have any question, contact your local CHARDER MEDICAL
service partner.
Below symbols are used in this manual for user’s attention to prevent
misunderstanding to the product, potential damages to the product, and potential
dangers could happen to users by misusing the products.
Note!
Definition: Pointing out possible problems to the user, or contents that may
confuse users and need to be clarified.
Caution!
Definition: Advice for the user to prevent damage to the product.
Warning!
Definition: Warnings for the user to prevent personal injury.
Without following these instructions may result in physical injury, damage to
the product or damage to the environment!
!
TROUBLESHOOTING
Troubleshooting for defective modes:
Original purchaser can enjoy the benefits under the effective Warranty
against functional defects in material and workmanship subject to the
terms and conditions listed in the yearly Warranty Program & Return
Policy.
Our warranty service program includes the following:
1. Technician repair service under warranty or at a service
maintenance charge depending on the workmanship for the
defective functionality or cause of damage covered by the
warranty.
2. Parts replacement from the manufacturing factory under the
warranty or at a certain cost for the replaced parts plus the
workmanship charge if not covered under the warranty.
Before you contact our Authorized Dealer in your country for technician
repair service, please read through the following section carefully:
Self-checking Tips:
Some functional defects can be identified and maintained by
users as listed below:
1. Power-on failure
Check if the main power adaptor has not plugged onto the scale
properly
Check if the battery power is running low - Replace with new
batteries
2. Indicator showing “0000” ZERO SPAN out of range
Incorrect weighing result - Avoid damages by external
environment force such as free-drop to the ground, collision by
external objects, etc.
Proper re-calibration procedure required to correct the setting
of weighing accuracy.
Interference due to RF disturbance, ground vibration…etc.
Unstable platform feet adjustments according to bubble level
To Next Page
Loading...
