32
2. The scale is below its zero
range. Check there is
nothing jammed
underneath the scale and
power on again. If the
scale continues to show
the error message, it
indicates a fault with the
electronics.
AD Error
This indicates there is a fault with
the scale’s software and is
normally caused by a fault with
the PC board. Contact your
local service representative.
Negative weighing
The weight reading is below -2kg.
Press ZERO to return to 0.0.
5
CLEANING
We would recommend using alcohol based wipes or similar when cleaning the
scales.
Please do not use large amounts of water when cleaning the scales as this will
cause damage to the scales electronics, you should also refrain from using
corrosive liquids or high pressure washers.
Always disconnect the scales from the mains power supply before cleaning.
MAINTENANCE
The scale does not require any routine maintenance. However, we recommend
checking the scale’s accuracy at regular intervals. The regularity of these
checks is dependent on the level of use and the state of the scale. If any
inaccuracies occur, please contact your local dealer or CHARDER MEDICAL
service partner.
WEIGHING OPERATION
Before reading detailed instructions on how to use all the weighing functions
that are built into your scale, please read the following important guidelines:
Always be sure that the display shows `Zero` before use, if it does not then
please press the ZERO key.
The Professional Medical scale is designed to detect when a stable weight is
achieved, the indicator will `beep` twice to indicate a stable weight value, your
reading should be taken at this point.
WARRANTY-LIABILITY
If a fault or defect is present on receipt of the unit which is within CHARDER
MEDICAL’s scope of responsibility, CHARDER shall have the right to either
repair the fault or supply a replacement unit. Replaced parts shall be the
property of CHARDER. Should the fault repairs or replacement delivery not be
To Next Page
Loading...
