EasyManua.ls Logo

Charder MS 4971 - Disposing of the Scale

Charder MS 4971
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
successful, the statutory provisions shall be valid. The period of warranty shall
be two years, beginning on the date of purchase. Please retain your receipt as
proof of purchase. Should your scale require servicing, please contact your
dealer or CHARDER MEDICAL Customer Service.
No responsibility shall be accepted for damage caused through any of the
following reasons: Unsuitable or improper storage or use, incorrect installation
or commissioning by the owner or third parties, natural wear, changes or
modifications, incorrect or negligent handling , overuse, chemical,
electrochemical or electrical interference or humidity, unless this is attributable
to negligence on the part of CHARDER MEDICAL.
If operating, climatic or any other influences lead to a major change in
conditions or material quality, the treaty for perfect unit functioning shall be
rendered null and void. If CHARDER provides and individual warranty, this
means that the unit supplied will be free of faults for the length of the warranty
period.
DISPOSING OF THE SCALE
This product is not to be treated as regular household waste, but should be
handed in to an electrical/electronic equipment recycling centre.
You can obtain further details from your local council, your municipal waste
disposal company or the firm which you purchased the product
31
ERROR MESSAGE
Low Battery
The scale’s AA type batteries are
flat; please replace the batteries.
Overload
This indicates that the scale’s load
sensor(s) have been overloaded.
Reduce the loading and retry.
Counting Error
The signal from the load cells is
too high or too low. Please
remove any weight from the
scale, switch the scale off and
power on again. If the scale
continues to show this message,
it indicates a fault with the
electronics or wiring.
High/Low Zero Count
1. The scale is above its zero
range. Please remove any
weight from the scale and
power on again. If the
scale continues to show
the error message, it
indicates a fault with the
electronics.

Related product manuals