What causes intermittent output on Chattanooga Revolution Wireless Medical Equipment?
Intermittent output may occur if an intermittent program is in use. This is expected behavior for some programs.
What to do if Chattanooga Medical Equipment stimulation is uncomfortable?
If the stimulation is uncomfortable, it might be due to several factors. First, the amplitude (intensity) may be too high, so decrease it. Second, the electrodes might be too close together; reposition them to be a minimum of 2 inches apart. Also, check if the electrodes or module leadwires are damaged or worn and replace if needed. Ensure the proper program is being used.
How to fix Chattanooga Revolution Wireless electrode failure?
Electrode failure can occur due to a poor electrode connection to the modules. Check that the electrodes are properly connected to the module. Another cause can be a poor electrode connection to the skin, so check if the electrodes are outdated, worn, and/or the contact is poor; try with new electrodes.
What to do if Chattanooga Revolution Wireless Medical Equipment stimulation stops with charged batteries?
If the stimulation stops even with charged batteries, it could be due to poor electrode contact. Reapply the electrodes and secure them firmly, ensuring they are a minimum of 2 inches apart. Alternatively, the electrodes or module leadwires may be damaged or worn, in which case you should replace them.
Why is Chattanooga Revolution Wireless stimulation ineffective?
If the stimulation is ineffective, it might be due to improper electrode placement. Reposition the electrodes, ensuring they are a minimum of 2 inches apart.
How to resolve Chattanooga Medical Equipment weak stimulation with charged batteries?
If you're experiencing weak stimulation even with charged batteries, the electrodes may have dried out, lost their adhesive power, and no longer have adequate connection to the skin. Replace the electrodes. Also, ensure proper electrode placement, maintaining at least 2 inches of space between them.
What to do if Chattanooga Medical Equipment module battery is low?
If a module's battery is low during stimulation, stop the stimulation and recharge the discharged module.
What causes stimulation weakening within minutes on Chattanooga Medical Equipment?
If the stimulation weakens within minutes of starting treatment with charged batteries, it is a normal body adaptive process. Increase the amplitude (intensity) if required.
How to resolve Chattanooga Revolution Wireless stimulation only felt on one electrode?
If stimulation is only felt on one electrode, it is likely due to improper electrode placement. Reposition the electrodes, ensuring they are a minimum of 2 inches apart. If the issue persists, replace the electrodes.
What to do if Chattanooga Revolution Wireless display does not come on?
If the display does not come on, it is likely due to low batteries. Charge the batteries.
General| Category | Medical Equipment |
|---|---|
| Wireless Technology | Bluetooth |
| Channels | 2 |
| Pulse Width | 50-400 μs |
| Battery | Rechargeable Lithium-ion |
| Wireless Range | Up to 10 meters |
| Power Output | 0-100 mA |
| Amplitude | 0-100 mA |
| Intensity Levels | Adjustable |
| Modes | Continuous, Burst |
| Programs | Pre-set and Customizable |
| Display | LCD |
| Power Source | Battery |
| Compatibility | Android and iOS devices |
To Next Page
