Why are the Chattanooga hydrocollator Medical Equipment packs too hot?
If the Chattanooga Medical Equipment packs are too hot, it might be because the thermostat is set too high. Try adjusting the thermostat. Alternatively, the thermostat may have failed and require replacement.
What to do if Chattanooga hydrocollator Medical Equipment packs are too cool?
If the Chattanooga Medical Equipment packs are too cool, it could be due to the thermostat being set too low. Try adjusting the thermostat. If that doesn't solve the problem, the thermostat may have failed and needs replacing.
Why does my Chattanooga Medical Equipment unit boil?
If your Chattanooga Medical Equipment unit is boiling, it is likely due to thermostat failure, which means you'll need to replace the thermostat.
Why is the water cloudy in my Chattanooga hydrocollator Medical Equipment?
Cloudy water in your Chattanooga Medical Equipment can occur for a couple of reasons. It could be filler seeping from the packs, in which case you should replace the packs. It may also indicate that too much time has passed between cleanings, so you should drain and clean the unit.
General| Material | Stainless Steel |
|---|---|
| Type | Stationary Heating Unit |
| Power Requirement | 120V, 60Hz |
| Heating Element | Immersion Heating Element |
| Temperature Range | 160°F - 165°F (71°C - 74°C) |
Defines CAUTION, WARNING, and DANGER levels for safety.
Provides helpful information to aid in particular areas or functions.
General precautions for operating the Hydrocollator Heating Units.
Specific warnings regarding operation and use of the heating units.
Warnings about grounding, placement, and electromagnetic interference.
Explanation of symbols used in the manual.
Explains the function of white and red indicator lamps.
Details on thermal cut-out thermostat and its operation.
Labeled diagram of the Hydrocollator unit components.
Shows internal and rear components of the unit.
Further labeled diagrams of unit components.
Diagram of the bottom view with J-Box open.
Technical specifications for the SS-2 model.
Technical specifications for the M-2 model.
Technical specifications for the M-4 model.
Technical specifications for the SS model.
Technical specifications for the E-2 model.
Technical specifications for the E-1 model.
Instructions for preparing the Hydrocollator Heating Unit for use.
Instructions for operating the Hydrocollator Heating Unit.
Important note regarding thermostat adjustment.
Information on HotPac rack capacity for different models.
Table listing common problems and their causes/solutions.
Identifies potential causes for unit malfunctions.
Provides solutions for troubleshooting unit issues.
List of replacement parts for the M-2 model.
Key to part numbers and descriptions for the M-2 model.
List of replacement parts for the SS-2 model.
Key to part numbers and descriptions for the SS-2 model.
List of replacement parts for the M-4 model.
Key to part numbers and descriptions for the M-4 model.
List of replacement parts for the SS model.
Key to part numbers and descriptions for the SS model.
List of replacement parts for the E-2 model.
Key to part numbers and descriptions for the E-2 model.
List of replacement parts for the E-1 model.
Key to part numbers and descriptions for the E-1 model.
Instructions for proper care and cleaning of the unit.
Warning about moving the unit with hot water.
Note on warranty voidance due to lack of maintenance.
Precautions to prevent rusting of the unit.
Specific tips for cleaning the unit interior and exterior.
Guidelines for the care and replacement of HotPacs.
Details of what is not covered by the warranty.
Disclaimer regarding liability for damages.
Instructions for obtaining warranty service.
To Next Page