Chattanooga hydrocollator - Troubleshooting Guide; Common Problems and Solutions; Problem Identification and Causes; Solution Implementation Steps

12
The following are solutions to minor performance problems. Only qualified personnel should service all other
equipment problems.
TROUBLESHOOTING
Hydrocollator
®
Heating Units
Problem Possible Cause Possible Solution
Unit plugged in,
Water does not get hot
Breaker for electric circuit off1.
Thermostat not functioning2.
Heating element burned out3.
Turn breaker on1.
Replace thermostat2.
Replace element3.
Cloudiness of water Filler from packs is seeping1.
Too long a period between 2.
cleanings.
Replace packs1.
Drain and clean2.
Packs too hot Thermostat set too high1.
Thermostat failure2.
Adjust thermostat1.
Replace thermostat2.
Packs too cool Thermostat set too low1.
Thermostat failure2.
Adjust thermostat1.
Replace thermostat2.
Unit boils Thermostat failure1. Replace thermostat1.
Rust/Discoloration Contact with ferrous material 1.
Deposits on inside of tank 2.
Too much chlorine in water3.
Remove the ferrous metal item from 1.
the unit (staple, paper clip, safety pin,
tongs, etc.) and clean thoroughly. Add
a dechlorinating agent if local water
has high chlorine content.
Thoroughly clean tank and remove all 2.
deposits.
Clean tank and rinse thoroughly. Add 3.
a dechlorinating agent if local water
has high chlorine content.