Check Point L-72 - Page 75

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 75
Table Columns
Description
Next Hop
The next hop gateway for this route, with these options:
• Specified IP address of the next hop gateway
• Specified Internet connection from the connections configured in the
appliance
• Specified VPN Tunnel Interface (VTI)
Metric Determines the priority of the route. If multiple routes to the
same destination exist, the route with the lowest metric is
selected.
To add a new static route (IPv4 addresses):
1.
In Device > Routing, above the Routing Table, click New.
The New Routing Rule window opens with this message: Traffic from any source to any
destination that belongs to any service should be routed through the next hop.
2.
Click next hop and select an option in the new window that opens:
• IP Address - Enter the IP address.
• Internet connection - Select an internet connection.
• VPN Tunnel (VTI) - Select the VPN Tunnel.
3.
Click OK.
4.
Click any source and select an option in the new window that opens:
• Any
• Specified IP address - Enter the IP Address and Mask
5.
Click any destination and select an option in the new window that opens:
• Any
• Specified IP address - Enter the IP Address and Mask
6.
Click OK.
7.
Click any service and select a service name or enter a service name in the search field. You
can create a new service or service group.
Note - Static routes are not supported for source based or service based routes.
8.
Optional - Enter a comment.
9.
Enter a Metric between 0 and 100. The default is 0.
10.
Click Apply.
To configure a default route:
1.
Go to Device > Local Network page.
2.
Select an interface and click Edit.
The Edit window opens in the Configuration tab.
3.
Click the DHCP Server options tab.
4.
In the Default Gateway section,
• Click Use this gateway's IP address as the default gateway.
Or
• Select Use the following IP address and enter an IP address.
5.
Click Apply.