Check Point Power-1 - Connecting to the Power-1 CLI

Advanced Configuration
Configuring Power-1 Page 14
Connecting to the Power-1 CLI
You can connect to the command line interface of the Power-1 appliance using:
 The provided serial console cable (DTE to DTE) and terminal emulation software such as
HyperTerminal (from Windows) or Minicom (from Unix/Linux systems).
Connection parameters for Power-1 appliances are: 9600bps, no parity, 1 stop bit (8N1).
 An SSH connection to the management interface (if sshd is configured).