Cheonsei MESTAR+ - Product Confirmation; General

4
3 General
Caution
• Do not use the controller of which case was damaged. If the controller is used, it may cause trouble to
equipment connected with the controller.
• Do not install controller in the heavy moist or dusty place. Electric shock and trouble may occur.
• Do not use power other than that specied in controller. Otherwise, it may cause malfunction or
re.
• Refrain from voltage withstand test in order to prevent damage of internal parts.
• Dispose of waste controller in accordance with related national law.
2-1 Check Point When Unpacking
Please check following points immediately after receiving the product.
If the defect is found from the product, please request it to local agent or CHEONSEI.

Is specication correct as ordered?

Is there any missing parts ?

Is there any visible damage caused by vibration or shock during transport?

Is there any loosened bolt or nut?
2-2 Components

Controller
•
Digital DO controller : 1Set
•
Bracket(SPC-1 M4
×
52) : 2EA
•
Instruction Manual : 1 COPY

SET Components
•
Refer to section 6.
2 Product Confirmation
This controller is a digital controller built-in micro processor. It can be used by composing circuit with the
external devices through dry contact of analog Input & output and, as option, it can be composed according
to wanted using condition by installing Communication card.
This controller is designed only for a high insulation shielded cable.
If you need to extend the electrode cable, refrain from using the general cable in market and use our high
insulation shielded cable.