25
WARNING FAILURE TO PROPERLY CLEAN PIPE MAY CAUSE
PLUG DISLODGEMENT OR PLUG FAILURE WHICH MAY RESULT IN
DEATH, SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE!
WARNING THESE RECOMMENDATIONS ARE TO BE USED
AS A GENERAL GUIDELINE ONLY! Although Cherne recommends these
guidelines, it does not warrant, represent or assume any responsibility
that these recommendations will fulll all applicable Federal, State or
Local requirements. Cherne assumes no liability for either personal
injury or consequential damages resulting from the reliance on these
recommendations. IT IS THE PRODUCT USER’S RESPONSIBILITY TO
READ AND COMPLY WITH ALL APPLICABLE REGULATIONS. Refer
to Code Of Federal Regulations, “CFR” Part 1926 and all other pertinent
Federal, State and Local regulations. FAILURE TO COMPLY WITH ALL
REQUIREMENTS MAY RESULT IN DEATH, SERIOUS BODILY INJURY
AND/OR SUBSTANTIAL FINANCIAL PENALTIES!
8. CLEAN PIPE BEFORE PLACING PNEUMATIC PLUG.
PROPERLY CLEAN THE PIPELINE BEFORE INSTALLING A
PNEUMATIC PLUG. Clean any debris or foreign substances which may
reduce back pressure holding capability from the pipe before the plug
is installed. Such foreign substances may include grease, mold, algae,
sediment, seashells, coral, sand and/or any other material that prevents
solid contact between the plug and the pipe wall. Cleaning methods may
include using a high pressure cleaner or by using a wire brush followed
with a water ush. Remove any sharp objects that may puncture plug upon
ination. If any debris remains in the pipe, it may cause the plug to seal
improperly or cause damage to the plug upon ination.
A WIRE
BRUSH AND
WATER FLUSH
MAY BE USED
CLEAN PIPE BEFORE
INSTALLING PLUG
To Next Page
Loading...