Cherry MultiBoard MY 7000 - Page 20

20
3 General bar code options
Options Programming string
(by keystroke)
Comment Default
1st 2nd 3rd 4th
Welch Allyn code
ID transmission
R 1 Y/N Y = enable; N = disable N
AIM code ID
transmission
R 2 Y/N Y = enable; N = disable N
AIM modifier
transmission
R 3 Y/N Y = enable; N = disable N
Laser voting R 4 Y/N Compare 3 consecutive scans before data
transmission; Y = enable; N = disable
Y
Buzzer for good
read
R 5 Y/N Y = buzzer on; N = buzzer off Y
Set all barcode
options to factory
default
R6
Disable all barcode
options
R7
Interface setting R 8 1-3 1 = automatic detection;
2 = barcode 1: wand & barcode 2: laser;
3 = barcode 1: laser & barcode 2: wand
1
Define barcode 1
header (& enable)
Q 3 [sequence] Enter
[num]
[sequence] = Enter the data you want
programmed here.
Enter [num] = Hit the numeric keypad enter
key to end programming sequence.
not def.
Disable barcode 1
header
Q1 N N
Define barcode 1
terminator
(& enable)
T 3 [sequence] Enter
[num]
[sequence] = Enter the data you want
programmed here.
Enter [num] = Hit the numeric keypad enter
key to end programming sequence.
not def.
Disable barcode 1
terminator
T1N N
Define barcode 2
header (& enable)
Q 4 [sequence] Enter
[num]
[sequence] = Enter the data you want
programmed here.
Enter [num] = Hit the numeric keypad enter
key to end programming sequence.
not def.
Disable barcode 2
header
Q2 N N
Define barcode 2
terminator
(& enable)
T 4 [sequence] Enter
[num]
[sequence] = Enter the data you want
programmed here.
Enter [num] = Hit the numeric keypad enter
key to end programming sequence.
not def.
Disable barcode 2
terminator
T2N N