Defroster
Check the operation by selecting the
defrost mode and place the blower
control on high speed. You should be
able to feel the air directed against
the windshield. See your authorized
Chery dealer for service if your de-
froster is inoperable.
Exterior Vehicle Safety Inspection
Tires
Examine tires for excessive tread wear
and uneven wear patterns. Check the
tires for the following:
• Stones, nails, glass, or other objects
lodged in the tread
• T read and sidewall for cuts and cracks
• Proper pressure (including spare)
• Wheel nuts for proper torque
Lights
Have an assistant observe the opera-
tion of exterior lights while you work
the controls. Check turn signal and
high beam indicator lights on the in-
strument panel. Check the following
lights for proper operation:
• Low beam headlamps
• High beam headlamps
• Turn signals
• Tail lamps
• Stoplamps
Fluid Leaks
Check the area under the vehicle after
overnight parking. If a leak is sus-
pected, the cause should be located
and corrected immediately. Check the
following for possible leaks:
• Fuel
• Engine coolant
• Engine oil
• Power steering fluid
• Brake fluid
New Vehicle Break-In
Recommendations
Engine Break-In
Recommendations
Vehicle frictional resistance is much
greater when the vehicle is new. The
result of proper engine break-in will
impact the service life, operating reli-
ability and vehicle economical effi-
ciency. The following is the proper en-
gine break-in procedure:
During first 1,000 km of operation:
• Do not allow the engine speed to ex-
ceed 3,000 rpm
• Do not exceed 100 km/h
• Do not operate the engine at maxi-
mum speed when upshifting
During 1,000-1,500 km of operation:
• Driving speed can be gradually in-
creased to greater than 100 km/h
• Engine speed can be gradually in-
creased to its maximum
30 – BEFORE OPERATING YOUR VEHICLE
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
