Door Lock & Theft Protection
Tank cup can be screwed down and placed
upon filler cap as shown in the figure
above.
Bonnet Opening
1. Pull handle of the bonnet is located in
the left front of driver’s side; pull the
pull handle backward to kick up the
bonnet partially.
2. Walk to the front of car, reach your
hand under the bonnet front to hold the
bonnet pull handle; push the pull
handle leftward, and pull the bonnet
upward. Pull up the release bar to open
the bonnet lock.
3. Raise the bonnet, which is supported
by two air shock eliminators.
4. In closing the bonnet, lower the bonnet
20-30cm away from bonnet lock and
then, let bonnet fall into latches to be
closed.
5. Remember to uplift the bonnet after it
has been closed for assuring that the
bonnet is fully locked.
Bonnet shall be tightly closed
in driving. In case of loosely
locked bonnet in driving,
immediately stop driving and close
the bonnet tightly.
To Next Page
Loading...
