Emergency Response
Accumulator cell is replaced with the
lead-acid accumulator instead of
other types of accumulator cells.
Current and capacity of new
accumulator cells must comply with
those of old accumulator cells or
Chery specifications. Consult Chery
chartered maintenance points for
correct specifications of accumulator
cell.
Dismount the cathode ( ﹣ ) cable
firstly after ignition switch and all
electrical devices have been already
turned off.
Please avoid carefully that metallic
tools touch upon both electrodes of
accumulator cell simultaneously or
touch upon the anode and vehicle
body accidentally.
Connect the anode (﹢) cable firstly
and then the cathode cable in
reconnecting accumulator cells.
Automobile may show some
abnormalities in performance in
early period of driving after
accumulator cell is dismounted and
reconnected. This indicates that the
control system of engine is
re-adapting to the engine. It can be
ignored.
Used accumulator cells contain
sulfuric acid and lead. They can’t
be discarded as ordinary
domestic waste. Please send them to local
waste disposal stations qualified.
Engine Jump-starting
Procedures
Accumulator cells with same rated
voltages (12V) can be connected only. Use
the jumper wires with insulating clips and
the cables of appropriate dimension. Don’t
dismantle accumulator cells from the
electrical system of your car.
Lead wire connection
To Next Page
Loading...
