Emergency Response
Wheel dismounting
1. Confirm that front wheel points right
ahead.
2. Turn off ignition switch.
3. Please select the position ―P‖ for
automatic transmission.
4. Ask passengers to leave the car.
5. Turn on hazard warning flasher and
pull up hand brake.
6. If necessary, use appropriate wheel
limit stop to fix the vehicle to prevent
rolling or sliding.
7. Insert the slotted point screwdriver
between steel ring and hub cap and
then twist it to dismount the hub cap.
8. Erect a triangle warning plate 100m
distant from the vehicle.
9. Use special tools to unscrew wheel
nuts, as indicated below.
10. Place the lifting jack to ensure the
whole pedal side is on the hard
ground.
11. Lifting jack must prop up the lifting
point vertically.
12. Prop up the vehicle until wheels leave
the ground.
13. Dismount wheel nuts and then take
down the wheel.
Wheel installation
6. Push the wheel into the wheel bolt,
screw down wheel nuts clockwise, and
fasten the wheel.
7. Jack down the vehicle and remove the
lifting jack.
8. Screw down wheel nuts fully in the
diagonal mode.
9. Press in the hub cap steadily with both
hands.
10. Keep the lifting jack and defective
wheel into place in a reverse order and
fix them.
11. Turn to Chery chartered maintenance
points for inspections of wheel nut
screwing torsion and tyre pressure.
Accumulator Cell
Safety tips
To Next Page
Loading...
