Air Conditioning System
Temperature regulation knob
Temperature regulation button is used to
control temperature of the air blown out of
ventilator scoops. The knob is rotated to
select appropriate temperature.
Blue range: Cooling
Red range: Heating
Cooling button
When ambient temperature is higher than
4℃, engine is running, wind speed
adjustment button for air blower is set at
any of the 4 gears, and air conditioning
system has a normal pressure, the
indicator lamp will be ON to start up the
air conditioning compressor for air
conditioning and cooling after the button
is pushed down. Push the cooling button
again to disenable air conditioning.
When the cooling system works, not only
the temperature inside can be reduced, but
also temperature of the air from outside
can be reduced, to make passengers more
comfortable and avoid fogging of vehicle
windows.
All vehicle windows should be closed to
achieve best cooling effect, when the
cooling system works.
Notice: Air conditioning enabled will
make engine over-heated when the car
climbs up a long slope or comes across
traffic congestion. Observe water
thermometer, and turn off the air
conditioning system if the engine is
over-heated.
Air conditioning compressor will consume
engine power when air conditioning is
used for cooling; thus, fuel consumption
will be increased.
Wind speed adjustment knob
for air blower
Wind speed adjustment knob for air
blower is used to control wind speed of air
blower (4 gears in total). Wind speed is
adjusted with air blower. To improve
comfort, air blower may be started up
during running.
To Next Page
Loading...
