SKU 3633 For technical questions, please call 1-800-444-3353. Page 8
INSPECTION, MAINTENANCE, AND CLEANING
1. CAUTION: Always release a load from the Winch, and disconnect the Winch
from its 12 Volt DC electrical supply source, before performing any inspection,
maintenance, or cleaning.
2. BEFORE EACH USE, inspect the general condition of the Winch. Check for
loose screws, misalignment or binding of moving parts, cracked, bent or broken
parts, frayed Cable (36), and any other condition that may affect its safe operation.
Inspect the entire unit for corrosion that may be caused by exposure to salt water
or weather. If abnormal noise or vibration occurs, have the problem corrected
before further use. Do not use damaged equipment.
3. PERIODICALLY, use a premium quality, lightweight oil to lubricate the Cable (36).
4. EVERY SIX MONTHS, Grease all moving parts. Use any good quality, water-
proof, gear grease.
5. TO CLEAN, wipe with a clean, damp cloth. If necessary, a mild detergent may be
used.
4. Pull out the Cable (36) to the desired length, using the “Power Out” feature located
on the Switch Assembly (35).
Always leave at least
four
turns of Cable on the
Drum (31) to prevent pulling the Cable completely out of the Winch.
(See Figure A.)
5. Hook onto the object using a pulling point, tow strap, or chain (all not included).
Never wrap the Cable (36) around the object or hook onto the object itself. This
can cause damage to the object being pulled, and kink or fray the Cable.
(See Figure A.)
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES
ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALI-
FIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTI-
FIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS
THERETO.
Brought to You by Augusta Flint
To Next Page
Loading...