RISK OF ELECTRICAL SHOCK!
THIS APPLIANCE IS DESIGNED TO OPERATE ONLY WITH
ALTERNATING CURRENT. BEFORE OPERATING, MAKE SURE THAT
THE VOLTAGE CORRESPONDS TO THE ONE INDICATED ON THE
DATA PLATE.
ONLY CONNECT THE APPLIANCE TO THE POWER OUTLETS WITH
A MINIMUM CAPACITY OF AMPERES.
DO NOT PULL THE POWER CORD OR THE APPLIANCE ITSELF TO
REMOVE THE PLUG FROM THE WALL SOCKET.
FULLY UNWIND THE POWER CORD BEFORE OPERATING THE
APPLIANCE.
USE AN ELECTRIC EXTENSION CORD ONLY IF IT IS IN PERFECT
CONDITION.
NEVER LET THE POWER CORD RUN THROUGH SHARP EDGES;
AVOID CRUSHING IT.
DO NOT LEAVE THE APPLIANCE EXPOSED TO ATMOSPHERIC
AGENTS RAIN, FROST, SUN, ETC..
EVER USE THE APPLIANCE:
WITH WET OR MOIST HANDS;
IF IT HAS FALLEN AND HAS OBVIOUS RUPTURES OR
MALFUNCTIONS;
IF THE PLUG OR POWER CORD DEFECTIVE;
IN HUMID OR GAS SATURATED ENVIRONMENTS.
DO NOT COVER THE APPLIANCE WITH TOWELS, CLOTHING, ETC.
PLACE THE APPLIANCE ONLY ON HORIZONTAL AND STABLE
SURFACES, AWAY FROM SHOWERS, BATHTUB, SINKS, ETC.
IF THE APPLIANCE IS WET OF GETS IN CONTACT WITH WATER,
To Next Page
Loading...
