Chigo 5902504 - Understanding Unit Behavior; Explanations for Operational Phenomena

 
WE HOPE YOU WILL KNOW THE FOLLOWING WHEN USING THE UNIT
The unit can not be restarted just after shut down.
(RUNlampisilluminating)
Notoperate
Restart is stopped for 3 minutes after shut down to protect
the unit.
Please wait for
3 minutes.
Three-minute protection timer incorporated in the microcomputer
actuates automatically, Except that power is connected, this
function does not actuate.
Air is not blown out at starting of heating operation.
Air blow is stopped to prevent blowing out of cold air until the
indoor heat exchanger is warmed. (2 to 5 min)
(HOT KEEP)
Theunitwllnotstopblowingouttheairimmediatelyaftershut
downatCOOLoperation(somemodel).
fanmotorrunsatlowspeed.Thelouverwillnotclosedownuntil
after30seconds.
Air is not blown out for 6 to 12 min, at heating operation.
When outdoor temperature is low and humidity is high, the unit
sometimes performs defrosting automatically. Please wait. During
defrosting, water or steam are raising from the outdoor unit.
Air is not blown out at DRY operation.
Indoor fan is sometimes stopped to prevent vapor of dehumidified
moisture and save energy.
Mist is blown out at COOL operation.
This phenomenon sometimes occurs when the temperature and
humicity of the room are very high, but it will disappear with the
lowering of the temperature and humidity.
Odor is sent out.
Air blown out during operation may smell. This is the smell of
tobacco or cosmetics sticked to the unit.
Noise is heard cracking sound.
This is caused by the refrigerant that is circulating inside the unit.
Noise is heard cracking sound. After a power stoppage or after
disconnecting the power supply plug.
This is caused by heat expansion or contraction of plastics.
Operation can not be restarted even if the power is recovered.
The memory circuit of the microcomputer is cleared. Operate the
remote controller again to restart the operation.
Remote control signals are not received.
Remote control signals may not be received when signal receiver
on the air conditioner body is exposed to direct sunlight or strong
lighting. In that case, interrupt the sunlight or darken the lighting.
Moisture may form on the air outlet grilles.
If the unit is operated for a long period of time with the high
humidity, moisture may form on the air outlet grilles and drip
down.