4. Adjust the angle of the camera, make sure you get
-max recording range of the road, and fasten all screw
-s.
5. Connect the power to the camera and the cigarette l
-ighter, hide the rest of the cable in the gap of the Inter
-ior trim board.
6. The rear camera should be installed above the num
-ber plate, screw pad upward, connect the red power c
-able to the reverse lamp.
7. Route the camera cable to the front of the car, and c
-onnect the rear camera to the main device. There are
2 pictures for reference.
8. Start the engine and have a test run.
Function introduction
Auto Recording Feature
When the car engine starts, the camera will automatic
-ally power on and start recording, the red power indic
-ator lights and blue indicator lights blinking. If the eng
support@chortau.cc
5
To Next Page
Loading...
