EasyManuals Logo

Chris-Craft Lancer 20 User Manual

Chris-Craft Lancer 20
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
PRE-LAUNCH CHECKLIST
_________ Drain plugs – installed (first visual check)
_________ Boat cover – removed
_________ Wheel chocks – available
_________ Equipment – loaded for proper trim
_________ Bow and stern lines – fastened
_________ Tiedowns – removed
_________ Fuel tanks – full
_________ Outboard or stern drive – tilted up and engine support removed (if applicable)
_________ Check boat systems (engine room blower, bilge pumps, lights, etc.) – operational
_________ Electrical connection to tow vehicle – unplugged
_________ Trailer wheel bearings – cool
_________ Ramp conditions, water depth, current – checked
_________ Drain plugs – installed (second visual check)
LAUNCHING CHECKLIST
_________ Station someone to help direct.
_________ Back straight down the ramp.
_________ Stop with trailer wheels at waters edge.
_________ Secure tow vehicle with parking brake and wheel chocks.
_________ Station helper to hold bow and stern lines from the ramp.
_________ Tighten winch brake and release anti-reverse lock. Do not disconnect winch cable.
_________ If equipped release tilt latch.
_________ Allow boat to slide off trailer.
_________ Unhook winch cable from bow and rewind or secure trailer.
_________ Pull boat to appropriate location and secure.
_________ Return trailer tilt to horizontal and lock.
_________ Remove chocks and drive tow vehicle and trailer from ramp.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chris-Craft Lancer 20 and is the answer not in the manual?

Chris-Craft Lancer 20 Specifications

General IconGeneral
BrandChris-Craft
ModelLancer 20
CategoryBoat
LanguageEnglish

Related product manuals