Installing the Boxer
harness connector
backplates
To secure the lamp driver harness connectors to prevent damage to the connectors, install the Boxer
Harness Connector kit.
Affected products
The following products are affected:
• Boxer 4K30
• Mirage 304K
Parts list
The following parts are required for the installation of the Boxer harness connector backplates.
• 003-005514-XX
Tools required for installation
Make sure the following tools are available during the installation.
• Long and stubby neck magnetic-tip ball drivers—2.5 mm, 3 mm, and 5 mm provided in
projector toolbox
• Needle nose wire cutter
Installing the Boxer Harness Connect Backplates Instruction Sheet 1
020-102015-01 R
ev. 1 (10-2015)
To Next Page
