Replacing the ICP Battery Technical Bulletin 1
020-200313-01 Rev. 1 (02-2015)
Replacing the ICP Battery
This document provides instructions for replacing the Integrated Cinema Processor (ICP) battery. If
the ICP battery fails, projector time settings can become inaccurate and automated events might
not run as expected.
The ICP battery replacement takes approximately 30 minutes. Christie recommends replacing the
battery every five years.
Affected products
• Christie CP2210
• Christie CP2215
• Christie CP2220
• Christie CP2230
• Christie CP4220
• Christie CP4230
• Christie Solaria One
• Christie Solaria One
+
Safety precautions
Prerequisites
• Replacement ICP battery (type BR2330)
• A USB flash drive with a minimum capacity of 8GB
• Texas Instruments ICP and Enigma Control Program
To request a copy of the software, contact Christie Technical Support.
Technical Bulletin
ELECTRICAL SHOCK HAZARD! Always turn off, disconnect, and disengage all power sources to the
projector before servicing. Failure to comply results in death or serious injury.
Only Christie accredited service technicians are permitted to open any enclosure on the projector and
only if the AC power has been fully disconnected. Failure to comply could result in minor or moderate
injury.
To prevent damage by static electricity, wear an anti-static wrist strap and follow anti-static protocols
when replacing the ICP battery.
To Next Page
Need help?
General
