Technical Bulletin
Cleaning projector optics
This document provides information and procedures for cleaning optical components in the Christie
cinema projectors identified in the products list.
Only these optical components can be cleaned:
• reflector
• integrator
• light engine prism
• projection lens
• UV filter
• IOS Lens 5
The procedures in this document must be performed by service personnel trained by Christie following
consultation with Christie support. Failure to follow this recommendation could result in damage to the
projector and void the warranty.
Typically, optical components do not need to be cleaned frequently if they are installed and operated in
a location that meets or exceeds the environmental standard recommended by Christie. Christie
recommends that all cinema projectors are installed and operated in an environment that meets or
exceeds Underwriters Laboratories (UL) standard 609.50 Pollution Degree 2 and ISO Class 9 Standard
for Office Environments.
Affected products
The following products are affected.
• Christie CP2000
• Christie CP2000-X
• Christie CP2000-XB
• Christie CP2000-SB
• Christie CP2000-ZX
• Christie CP2208
• Christie CP2210
• Christie CP2215
• Christie CP2220
• Christie CP2230
• Christie CP4220
• Christie CP4230
• Christie Solaria One
• Christie Solaria One+
Safety precautions
When cleaning optical components, observe these important safety rules to avoid personal injury or
damage to the projector.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
Cleaning Projector Optics Technical Bulletin 1
020-200298-04 Rev. 1 (08-2017)
Copyright
©
2017 Christie Digital Systems USA Inc. All rights reserved.
To Next Page
Need help?
General
