Christie I Series User Manual (English)

To Next Page

Coolant Refill Instruction Sheet 1 of 9

020-100686-01 Rev. 1 (03-2011)

Coolant Refill

Instruction Sheet

INTRODUCTION

The following procedure should be performed whenever the coolant system needs to be refilled.

NOTICE: Never allow the pump to run dry to avoid damaging it.

KITS REQUIRED

• #003-001837-xx Coolant Refill Kit (includes JeffCool E105 jug of coolant, refill bottle, funnel, MSDS sheet)

INSTRUCTIONS

SERIES I

Series 1 projectors include the CP2000-S/-SB/-h/-i/-X/-XB/-Z/-M/-MR and the Roadie 25K/HD+30K/

HD+35K. For details on how to flush the coolant system on these models refer to, Roadie 25K/

HD+30K/HD+35K, CP2000-S/-SB/-h/-i/-X/-XB/-M/-MR/-ZX Coolant Flush Instruction Sheet

(P/N: 020-100179-03).

CP2000-S/-SB/-H/-I/-X/-XB AND ROADIE 25K/D+30K/HD+35K

ACCESS COOLING SYSTEM

1. Remove the projector lid. On the Roadie 25K/HD+30K/HD+35K or CP2000-X/-XB, open the

igniter door (Figure 1, left). On a CP2000-S/-SB/-i/-h (Figure 1, right), open the non-operator

side pedestal door and skip to Step 3.

Figure 1 Access Cooling System

Need help?

Do you have a question about the Christie I Series and is the answer not in the manual?

Christie I Series Specifications

General

Model	I Series
Type	DLP Projector
Brightness	Varies by model (I Series offers a range of brightness levels)
Resolution	Varies by model (including 2K and 4K options)
Contrast Ratio	Varies by model
Light Source	Laser
Connectivity	HDBaseT
Lens Options	Multiple interchangeable lenses
Throw Ratio	Varies depending on the lens option
Input Lag	Varies by model (typically low for professional use)
3D Capability	Yes
Weight	Varies by model