Christie Roadster S+12K Replacement Instructions

Lamp and Filter Replacement Instructions
013-100049-03 (Rev.1) 1 of 8 Pages
Introduction
Use the following instructions when replacing the lamp or filters in any of the projectors
listed in Table 1, below. The lamp is located at the rear of the projector (below the input
panel) and can be accessed by opening the lamp door. Use only a Christie approved Lamp
and Filter Kit for your specific projector model.
Projector Model Model Number Lamp Type (Watts) Lamp/Filter Kit Required
Roadster S
+
12K 38-DSP210-01
38-DSP210-02
38-DSP210-52
1.9kW
03-900519-01P
03-900519-01P
03-900519-51P
Roadster S
+
16K 38-DSP214-01
38-DSP214-03
38-DSP214-53
2.4kW
03-900518-01P
03-900518-01P
03-900518-51P
Mirage S
+
14K 38-DSP214-04
38-DSP214-54
2.4kW
03-900518-01P
03-900518-51P
Roadster S
+
20K 104-001001
104-001101-01
3.0kW
003-000306
003-000306-02
Warnings
Lamp replacement MUST be performed by a qualified service technician.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Christie (Refer to Table 1. Projector
Models) and read the Lamp Replacement Procedure in its entirety before proceeding.
Do not touch the glass surface of the lamp. Fingerprints left on the surface can lead
to an intense accumulation of heat known as a “hotspot”, which could potentially
result in the lamp shattering. It is recommended to wear clean, lint-free gloves and a
face shield when working with the lamp.
Table 1. Projector Models
OFFICIALLY RELEASED
Document Control
August 29, 2006

Christie Roadster S+12K Specifications

General

Brand	Christie
Model	Roadster S+12K
Category	Projector
Language	English