Chromalox 2104 User Manual

78 Chromalox 2104 Technical Manual
Sensor
Input
Calibration
(continued)
6. Wait 30 seconds for the electronics to stabilize.
Press ▲. Dashes will appear in the lower display
while the controller calibrates the high end of
span. When finished, the controller will display
DONE.
CALSCALS
CALSCALS
CALS
ININ
ININ
IN
HH
HH
H
II
II
I
AUX ▲▼
RESET
CALSCALS
CALSCALS
CALS
--------
--------
----
AUX ▲▼
RESET
➮➮
CALSCALS
CALSCALS
CALS
DONEDONE
DONEDONE
DONE
AUX ▲▼
RESET
☛
7. Press RESET to exit calibration.
Remote
Setpoint
Input
Calibration
The Remote Setpoint Input is calibrated using an
appropriate 4-20mA or 1-5 Vdc simulator.
Calibration is performed in the menu CALR on the
Input Page.
1. Connect the simulator to the remote setpoint
input terminals.
2. Go to menu CALR. The lower display will show
INLO, indicating that you should first calibrate the
input low end (4mA or 1 Vdc).
CALCAL
CALCAL
CAL
RR
RR
R
ININ
ININ
IN
LL
LL
L
OO
OO
O
AUX ▲▼
RESET

Chromalox 2104 Specifications

General

Brand	Chromalox
Model	2104
Category	Temperature Controller
Language	English